[Porting] Call for Testers
- 
 I have installed the image on my OnePlus 5. This is my test result. Actors: Manual brightness //Works 
 Actors: Notification LED //doesn't work
 Actors: Torchlight //works
 Actors: Vibration //works
 Bluetooth: Driver loaded at startup //doesn't work
 Bluetooth: Enable/disable and flightmode works //doesn't work
 Bluetooth: Persistent MAC address between reboots //unknown
 Bluetooth: Pairing with headset works, volume control ok //unknown
 Camera: Flashlight //works
 Camera: Photo //works
 Camera: Video //works but Media Player app can only play the first frame (video file works on PC)
 Camera: Switch between back and front camera //works
 Cellular: Carrier info, signal strength //works, not stable
 Cellular: Data connection //works
 Cellular: Incoming, outgoing calls //doesn't work and sometimes crashes (VoLTE-only carrier)
 Cellular: MMS in, out
 Cellular: PIN unlock
 Cellular: SMS in, out //SMS in works. SMS out doesn't work
 Cellular: Change audio routings
 Cellular: Voice in calls
 Cellular: Switch connection speed between 2G/3G/4G works for all SIMs
 Cellular: Enable/disable mobile data and flightmode works //works
 Cellular: Switch preferred SIM for calling and SMS - only for devices that support it
 Endurance: Battery lifetime > 24h from 100%
 Endurance: No reboot needed for 1 week
 GPU: Boot into UI //works
 GPU: Hardware video decoding
 Misc: Anbox patches applied to kernel
 Misc: AppArmor patches applied to kernel
 Misc: Battery percentage //works
 Misc: Offline charging (Power down, connect USB cable, device should not boot to UT) //doesn't work, boot to OnePlus logo and hang?
 Misc: Online charging (Green charging symbol, percentage increase in stats etc) //works but no charging symbol
 Misc: Recovery image builds and works
 Misc: Reset to factory defaults
 Misc: Date and time are correct after reboot (go to flight mode before)
 Misc: SD card detection and access - only for devices that support it
 Misc: Shutdown / Reboot //works
 Misc: Wireless charging - only for devices that support it
 (Network: NFC - disabled atm due to no middleware)
 WiFi: Driver loaded at startup //sometimes WiFi status is not shown right. try rebooting
 WiFi: Enable/disable and flightmode works //works
 WiFi: Persistent MAC address between reboots //works
 WiFi: Hotspot can be configured, switched on and off, can serve data to clients //works but interferes with WiFi. Hotspot status is not shown right.
 Sensors: Automatic brightness //works
 Sensors: Fingerprint reader, register and use fingerprints (Halium 9.0 only) //doesn't work
 Sensors: GPS //doesn't work
 Sensors: Proximity //works
 Sensors: Rotation //works
 Sensors: Touchscreen //works
 Sound: Earphones detected, volume control //works
 Sound: Loudspeaker //works
 Sound: Microphone //works
 Sound: Loudspeaker volume control //works
 USB: MTP access //works
 (USB: ADB access - disabled atm due to no middleware)
 USB: External monitor - only for devices that support it //doesn't worksshd works 
 apt doesn't work
 Libertine doesn't work
 USB keyboard and mouse works
 back button, home button and menu button doesn't work
- 
 Hi, I have installed ubuntu touch like in https://pad.ubports.com/p/HaliumHowToTestInstall. 
 when I Issue ./halium-install-standalone.sh -p ut -s ubuntu-touch-android9-arm64.tar.gz system.img - I get: Chosen rootfs is ubuntu-touch-android9-arm64.tar.gz Chosen rootfs is ubuntu-touch-android9-arm64.tar.gz
  Chosen android image is system.img Chosen android image is system.img
  Chosen release is ut Chosen release is ut
  Compress images before pushing: false Compress images before pushing: falseI: Writing rootfs into mountable image 
 I: Writing android image into mountable image
 I: Running post installation tasks
 enabling SSH ... [done]
 Please enter a new password for the user 'phablet':
 Geben Sie ein neues UNIX-Passwort ein:
 Geben Sie das neue UNIX-Passwort erneut ein:
 passwd: password updated successfully
 I: Copying ssh key to the user 'phablet'
 I: Shrinking images
 e2fsck 1.45.6 (20-Mar-2020)
 resize2fs 1.45.6 (20-Mar-2020)
 Die Größe des Dateisystems auf .halium-install-imgs.ymhtd/system.img wird auf 118902 (4k) Blöcke geändert.
 Start von Durchgang 3 (max = 24)
 Die Inode-Tabelle wird gelesenXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
 Das Dateisystem auf .halium-install-imgs.ymhtd/system.img is nun 118902 (4k) Blöcke lang.I: Unmounting images 
 I: Pushing rootfs and android image to /data via ADB
 I: Pushing rootfs to /data via ADB
 adb: error: failed to get feature set: no devices/emulators found
 I: Pushing android image to /data via ADB
 adb: error: failed to get feature set: no devices/emulators found
 I: Renaming to system-as-root compatible system image
 adb: no devices/emulators foundreal 0m0,012s 
 user 0m0,010s
 sys 0m0,000s
 Error: Couldn't copy the files to the device, is it connected?
 I: Cleaning up
 umount: .halium-install-rootfs.UI62L: nicht eingehängt.
 adb: no devices/emulators foundany hints ? Michael 
- 
 @michi2302 Is your phone in recovery mode? 
 Checkadb devices
- 
 yes, fastboot devices is ok, but adb devices doesnot show any device when phone is in fastboot mode usb debugging is on 
 phone is unlocked
- 
 @michi2302 said in [Porting] Call for Testers: yes, fastboot devices is ok, but adb devices doesnot show any device when phone is in fastboot mode adb devices never shows any devices when the phone is in fastboot mode. Unless you meant to say recovery mode, the behavior described is expected. 
- 
 yes thats it - my phone was allways in fastboot-mode - new in recovery-mode all was fine  - THX - THX
- 
 so next problem, after successful installation - my phone is in the 1+ logo powered by android ?? 
 I had originally installed a custom rom with trwp - maybe that's the problem ?
- 
 @michi2302 I am not sure there already is a custom boot logo for the Oneplus 5/5T. As long as your phone boots into Ubuntu Touch, then all is well. 
- 
 @arubislander thx for reply right - the bootlogo is probably from android 11 - other question to run "./halium-install-standalone.sh -p ut -s ubuntu-touch-android9-arm64.tar.gz system.img" 
 I have the recovery.img from "http://twoot.bin.org.in/nextcloud/index.php/s/2Zk2Lz8cZCdqArT"
 installed is that correct ? - because without recovery adb will not run.thx 
- 
 @arubislander no phone does´t boots in Touch hangs on android boot logo 
- 
 I will have to gracefully bow out now, as I do not have a OP 5/T. 
 But just to get this clear for anyone dropping by to help you. You are in fact saying the installation failed because your phone does not boot to Ubuntu Touch. Correct?
- 
 @arubislander 
 yes, right - no problems during installprocess. but phone does not boot to ubuntu touch.
- 
 @michi2302 
 You can fastboot into TWRP and use adb shell to connect to your phone and examine the image files.
 They are in /data/.
 android-rootfs.img (size 487022592)
 rootfs.img (size 3221225472)
 Sizes from my working OnePlus 5.You can also check if you have flashed halium-boot.img and vendor.img. 
 fastboot flash boot halium-boot.img
 fastboot flash vendor vendor.img
- 
 I did half of the device checks, I'll do the rest later. Working Actors: Manual brightness 
 Actors: Torchlight
 Actors: Vibration
 Bluetooth: Driver loaded at startup
 Bluetooth: Enable/disable and flightmode works
 Bluetooth: Persistent MAC address between reboots
 Bluetooth: Pairing with headset works, volume control ok
 Camera: Flashlight
 Camera: Photo
 Camera: Video
 Camera: Switch between back and front camera
 Cellular: Carrier info, signal strength
 Cellular: Data connection
 Cellular: PIN unlock
 Endurance: Battery lifetime > 24h from 100%
 GPU: Boot into UI
 Misc: Shutdown / Reboot
 Misc: Battery percentage
 WiFi: Driver loaded at startup
 WiFi: Persistent MAC address between reboots
 WiFi: Enable/disable and flightmode works
 Sensors: Automatic brightness
 Sensors: Rotation
 Sensors: Touchscreen
 Sound: Loudspeaker
 Sound: Loudspeaker volume control
 Sound: Microphone
 Sound: Earphones detected, volume controlNot working Actors: Notification LED 
 Misc: Date and time are correct after reboot (go to flight mode before)
 Misc: Online charging (Green charging symbol, percentage increase in stats etc) #No green charging symbol
 Misc: Offline charging (Power down, connect USB cable, device should not boot to UT) #Boots into Oneplus logo
- 
 @ianus can I also use Helium-recovery instead of twrp ? thx for reply 
- 
 This post is deleted!
- 
 @michi2302 
 I don't know. But
 fastboot boot twrp-xy.img
 will not overwrite your boot or recovery partition on the phone. The phone will boot directly from the image file.
- 
 @michi2302 No, sorry, the Halium recovery does currently not mount all the partitions correctly, and it wont give a warning, so if you try to push files with adb they are just pushed into tmpfs mounts. You can use it if you manually mount data in recovery. But for the moment I recommend TWRP, our recovery will only be needed when we have OTA updates in place 
- 
 @ianus thx for reply 
 my /data is empty ?michi@Core5M:~/Downloads$ adb shell 
 root@OnePlus5:/ # ls /data
 root@OnePlus5:/ #regards 
- 
 @ianus 
 now I have tested ./halium-install-standalone.sh -p ut -s ubuntu-touch-android9-arm64.tar.gz system.imgand after success I had: adb shell root@OnePlus5:/ # cd data 
 root@OnePlus5:/data # ls
 android-rootfs.img rootfs.imgand then I reboot phone check again and /data is emty ?? 

