[Beta] Pixel 2 installer config

flohack

@i2097i Did you mount data? can you check with simply typing mount ? Its unlikely that it is fully empty

i2097i

My bad - I did not run mount data. Now adb shell is just hanging. Is there some where that I can see logging for this?

flohack

@i2097i No, adb is a very quiet protocol - try unplug/replug and reconnect

flohack

@i2097i Or do you mean the mount command does not finish?

i2097i

@Flohack

this is the general gist of what I am doing:

adb reboot recovery && adb wait-for-recovery && adb shell "mount data" && adb shell "ls -la /data"

I haven't been able to get any adb commands to run on the device itself (adb devices works)

flohack

@i2097i Just try to get adb shell working to get an interactive shell

i2097i

@Flohack same issue - I'm going to factory restore this device and try again. I'll post my findings asap.

flohack

@i2097i a simple adb shell should never get stuck, yes do that plz. And use an Android 9 image maybe to flash a few system partitions with the right version

i2097i

@Flohack Yeah, the hanging of adb shell is likely on my end somehow. I am going to try a different cable along with rebuilding.

Yeah, I'll have to get these partitions cleaned up . I've been using the last Pie update PQ3A.190801.002 (5670241) to refresh.

flohack

@i2097i I agree thats the one I would have taken too

agates

@flohack I was able to boot into that image and list the data partition:

agates@risa ~/D/ubports> fastboot flash boot boot_2021-09-03.img
Sending 'boot_a' (32768 KB)                        OKAY [  0.777s]
Writing 'boot_a'                                   OKAY [  0.155s]
Finished. Total time: 0.937s
agates@risa ~/D/ubports> adb devices
* daemon not running; starting now at tcp:5037
* daemon started successfully
List of devices attached
FA79F1A09215    recovery

agates@risa ~/D/ubports> adb shell
root@walleye:/ # mount /data
root@walleye:/ # ls -lh /data
total 2.0K
drwx------ 4 root root 4.0K 1972-09-14 01:27 android-data
root@walleye:/ # mount
rootfs on / type rootfs (rw)
tmpfs on /dev type tmpfs (rw,nosuid,relatime,size=1853348k,nr_inodes=463337,mode=755)
devpts on /dev/pts type devpts (rw,relatime,mode=600,ptmxmode=000)
proc on /proc type proc (rw,relatime,gid=3009,hidepid=2)
sysfs on /sys type sysfs (rw,relatime)
tmpfs on /mnt type tmpfs (rw,nosuid,nodev,noexec,relatime,size=1853348k,nr_inodes=463337,mode=755,gid=1000)
none on /acct type cgroup (rw,relatime,cpuacct)
tmpfs on /tmp type tmpfs (rw,relatime,size=1853348k,nr_inodes=463337)
tmpfs on /storage type tmpfs (rw,relatime,size=1853348k,nr_inodes=463337,mode=050,gid=1028)
pstore on /sys/fs/pstore type pstore (rw,relatime)
none on /config type configfs (rw,relatime)
adb on /dev/usb-ffs/adb type functionfs (rw,relatime)
/dev/block/sda45 on /cache type ext4 (rw,relatime,errors=remount-ro,stripe=4096,data=ordered)
/dev/block/sda45 on /data type ext4 (rw,relatime,errors=remount-ro,stripe=4096,data=ordered)

flohack

@flohack Ok perfect so data is empty currently. Can you please just boot into normal boot, and then try to do telnet 192.168.2.15 after lets say 20 secs on the Google logo? Thanks!

agates

@flohack No change in behavior

flohack

@agates ok can you check on your host what dmesg gives you, any mention of an RNDIS adapter coming up when booted normally?

flohack

Oh and please see again in recovery if you can also mount system partition (mount /system_root could do it). And whats inside there...

agates

@flohack said in [Beta] Pixel 2 installer config:

@agates ok can you check on your host what dmesg gives you, any mention of an RNDIS adapter coming up when booted normally?

Here's the dmesg log, from recovery (first disconnect) -> normal reboot -> force reboot into bootloader

agates@risa ~> sudo dmesg --follow-new
[73050.471900] usb 3-2: USB disconnect, device number 6
[73182.441061] usb 3-2: new high-speed USB device number 7 using xhci_hcd
[73182.589728] usb 3-2: New USB device found, idVendor=18d1, idProduct=4ee0, bcdDevice= 1.00
[73182.589735] usb 3-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[73182.589738] usb 3-2: Product: Android
[73182.589739] usb 3-2: Manufacturer: Google
[73182.589741] usb 3-2: SerialNumber: FA79F1A09215
[73186.703138] usb 3-2: USB disconnect, device number 7
[73212.553220] usb 3-2: new high-speed USB device number 8 using xhci_hcd
[73212.702787] usb 3-2: New USB device found, idVendor=18d1, idProduct=d001, bcdDevice= 4.04
[73212.702794] usb 3-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[73212.702796] usb 3-2: Product: Pixel 2
[73212.702798] usb 3-2: Manufacturer: Google
[73212.702799] usb 3-2: SerialNumber: FA79F1A09215

agates

@flohack said in [Beta] Pixel 2 installer config:

Oh and please see again in recovery if you can also mount system partition (mount /system_root could do it). And whats inside there...

root@walleye:/ # mount /system_root
root@walleye:/ # ls -alh /system_root                                                                                                                                                                                                                                                                                        
total 58K
drwxrwxr-x  24 audio camera 4.0K 2021-08-26 08:03 .
drwxr-xr-x  24 root  root      0 1972-09-19 23:20 ..
drwxr-xr-x   2 root  root   4.0K 2021-08-29 06:04 android
lrwxrwxrwx   1 root  root     13 1972-09-14 01:28 apex -> /android/apex
drwxr-xr-x   2 root  root   4.0K 1972-09-14 01:28 bin
drwxr-xr-x   2 root  root   4.0K 2016-04-12 20:14 boot
lrwxrwxrwx   1 root  root     14 1972-09-14 01:28 cache -> /android/cache
lrwxrwxrwx   1 root  root     13 1972-09-14 01:28 data -> /android/data
drwxr-xr-x   3 root  root   4.0K 1972-09-14 01:28 debian
drwxr-xr-x   4 root  root   4.0K 1972-09-14 01:28 dev
drwxr-xr-x 115 root  root   4.0K 1972-09-14 01:29 etc
lrwxrwxrwx   1 root  root     16 1972-09-14 01:28 factory -> /android/factory
lrwxrwxrwx   1 root  root     17 1972-09-14 01:28 firmware -> /android/firmware
drwxr-xr-x   3 root  root   4.0K 1972-09-14 01:28 home
-rwxr-xr-x   1 root  root   9.4K 2021-04-13 21:11 init
drwxr-xr-x  20 root  root   4.0K 1972-09-14 01:28 lib
drwx------   2 root  root    16K 1972-09-14 01:27 lost+found
drwxr-xr-x   2 root  root   4.0K 2021-08-26 22:22 media
lrwxrwxrwx   1 root  root     17 1972-09-14 01:28 metadata -> /android/metadata
drwxr-xr-x   3 root  root   4.0K 1972-09-14 01:28 mnt
lrwxrwxrwx   1 root  root     12 1972-09-14 01:28 odm -> /android/odm
drwxr-xr-x   3 root  root   4.0K 1972-09-14 01:28 opt
lrwxrwxrwx   1 root  root     16 1972-09-14 01:28 persist -> /android/persist
drwxr-xr-x   2 root  root   4.0K 2016-04-12 20:14 proc
lrwxrwxrwx   1 root  root     16 1972-09-14 01:28 product -> /android/product
drwx------   2 root  root   4.0K 1972-09-14 01:28 root
drwxr-xr-x  12 root  root   4.0K 1972-09-14 01:28 run
drwxr-xr-x   2 root  root   4.0K 1972-09-14 01:28 sbin
drwxr-xr-x   2 root  root   4.0K 2021-08-26 22:22 srv
drwxr-xr-x   2 root  root   4.0K 2016-02-05 09:48 sys
lrwxrwxrwx   1 root  root     15 1972-09-14 01:28 system -> /android/system
drwxrwxrwt   2 root  root   4.0K 2021-08-26 22:32 tmp
drwxr-xr-x   2 root  root   4.0K 2021-08-29 06:04 userdata
drwxr-xr-x  10 root  root   4.0K 1972-09-14 01:28 usr
drwxrwxr-x  11 audio camera 4.0K 2021-08-26 08:03 var
lrwxrwxrwx   1 root  root     15 1972-09-14 01:28 vendor -> /android/vendor

flohack

@agates Okay so you got already some potential UT data in your system partition. Please wipe that too, so that data nd system are clean, then the boot should drop into a telnet session on 192.168.2.15

flohack

@agates Oh and I forgot one important step, download vbmeta and dtbo image from here: http://twoot.bin.org.in/nextcloud/index.php/s/mzfmYJscqPyM2Bc

and then flash it with:

fastboot flash dtbo dtbo.img
fastboot --disable-verity --disable-verification flash vbmeta vbmeta.img

Thats to ensure you have no error from verity during boot.

agates

@flohack Hmmm, well now I'm in a boot loop. At least it's something different :). After the google logo I get a temporary black screen before it reboots.

And I still can't telnet

Both system and data are empty:

root@walleye:/ # ls -alh /data
total 0
drwxr-xr-x  2 root root 0 1970-01-01 00:00 .
drwxr-xr-x 24 root root 0 1972-09-20 23:41 ..
root@walleye:/ # ls -alh /system_root
total 0
drwxr-xr-x  2 root root 0 1970-01-01 00:00 .
drwxr-xr-x 24 root root 0 1972-09-20 23:41 ..