@pachof said in I need help to install an Ubuntu touch port:

I still believe that the Redmi Note 8 cell phone has the potential to become an Official Port.

That fully depends on the porter/maintainer, maybe you can even help them a bit?
In any case, good luck!

@RobertFojcik does not work

@migue5862 hi,
I went though more or less this same process.

Unfortunately I don't know if there is a good solution to the IMEI issue. but I stopped looking into it because I did finally find the solution for the UT update (the device is actively supported and 16.04 OTA-25 and 20.04 dev are available). There are just an unfortunate pairing of bugs that causes it to be a real pain to setup the device.

I added my best shot at documenting the problem/solution on the issue on the begonia gitlab page

As far as the IMEI goes, my suspicion is that the UB ports installer version for the note 8 uses android 9 to get around the adb issues that the note has in halium 10, and from the interwebs there seemed to be some indication that the android 9 formatting doesn't line up with the android 10 (or 11) firmware. If this is true there could be the chance that after getting the note updated to a current version of UT you may be able to re-install miui without IMEI issues.

@jhayar0719 said in [REQ] : Redmi note 8 pro guide:

@arubislander
hi , it means i can just install TWRP and replace UT recovery ?

Yes, of course. As long as you can boot up into fasboot/bootloader mode you can flash any recovery you like. But only do this if and when you want to flash Android.

will it work without problem ?
thanks 🙂

That depends on how closely you follow the instructions you find online, and if they are any good to begin with.