Unsolved VPN works fine with IPV4 but IPV6 is still my original one
I'm new to this site. I'm Patrick.
Set up my UT phone pixel 3a yesterday and set up an old NordVPN account manually. Works fine BUT if I check the IP the V4 is in that state I choose and the V6 is my original. I didn't find a solution so far. Also tried to enable IPV6 with Terminal sudo nano but it says it's a read only system.
Has anyone an idea?
Some info for my VPN setting:
Using VPN editor
Remote is the correct server [...] .30:1194
Type is password
CA certificate downloaded by NordVPN
Use gate 1194
Use LZO (a must with UT and NordVPN)
use custom VDT: TUN
Use MTU 1500
Cipher aes 256 cbc
With HMAC sha 512
Use additional Tls (uploaded key correct from server list)
Key direction 1
Looking forward for some ideas.
Thanks a lot
I wasn't able to set up vpn but these settings using vpn editor worked for me!
I have exactly the same after a setup with ProtonVPN. Is there a solution to unset the IPV6 address or also get a address via the VPN provider?