Recent update results in boot loop
-
Getting the same after this update.
-
@be7b5
On same device ? -
@keneda Yes, Jingpad A1.
-
@fredldotme have you noticed this thread?
-
Just finished reflashing with the installer while leaving user data intact. It worked well. Just had to reinstall waydroid and it's like nothing had happened.
-
@be7b5 This is good news. Thanks
-
@be7b5 Can you give a few more details on how you did this? I can reboot into the UT bootloader menu and navigate. The UBports installer correctly identifies the JingPad A1/C1 (mine is C1) when the JingPad is in recovery.
The installer downloads the image and reboots to fastboot mode. The JingPad screen shows fastboot mode.
Flashing appears to begin but 2 times I have waited for 30 minutes each and nothing happens. The installer does say: Flashing firmware with the dots showing activity. But nothing.
I am using Linux as I did before. Later tonight I might try from a Windows box.
-
@el_pinguino Do you happen to have USB 2 and USB 3 ports on your computer. Issues have been reported using USB 3 ports, that seem to be avoided when using USB 2 ports.
-
@arubislander said in Recent update results in boot loop:
@el_pinguino Do you happen to have USB 2 and USB 3 ports on your computer. Issues have been reported using USB 3 ports, that seem to be avoided when using USB 2 ports.
My Intel NUC is all USB 3.0. However, this is the computer I initially installed UT with. And the same USB cable.
In a terminal adb sees the JingPad serial number and shows recovery mode. I start the installer and it recognizes the JingPad and the asks me what OS I want to install and I choose UT (only choice). Next step is the install options and I choose to not wipe personal date. Bootstrap only. Then it reboots to fast boot and says flashing firmware... until I power off. This time I let it 'flash' and changed my guitar strings. Plenty of time.
I tried to use the Windows box but I've forgotten the password. The only reason I have a Windows box was to unlock the JingPad bootloader.
I'll wait and see what happens with others in the future.
-
Update: I found the password to the Windows box and tried to install UT from there. I downloaded the installer version 0.8.9 for Windows. (Linux had a newer version 0.9.5 ) I used USB 2.0 connection.
The installer recognized the JingPad when the JingPad was in Recovery Mode and rebooted the JingPad to bootloader mode. The installer asked all of the same questions as on the Linux box. This process failed in the same manner as the Linux box.
Over the next few days, I'll explore the idea of reinstalling JingOS/Jing Android and starting fresh.
-
2nd Update: I have reflashed the update and the JingPad is working with personal data untouched as far as I know. The system says up to date with OTA 23.
The key was to uncheck both wipe personal data and bootstrap during installation. (wipe personal data is already unchecked)
To recap: I did this on a Ubuntu 20.04 box with UBports installer 0.9.5 with USB 3.0
1: I powered on the JingPad to Recovery mode
2: Plugged in the USB cable
3: I started the installer and it found the JingPad and I clicked through to Install. -
I cannot get into recovery mode
Boot loops until the battery dies. Any ideas?Right, got into recovery mode, think the problem was I left it connected to computer as battery had died.....
