Did I brick my JingPad with the UBPorts installer?
-
When I ran the installer, I put the JingPad into fastboot mode. The installation process kind of started but stalled after a while, losing the USB connection. After that I never again managed to get back into the bootloader menu. Did I completely brick my device? Can I still charge it without an operating system installed? Thanks for any replies or help.
-
@miy It should charge as is and I think
adb reboot bootloader
Will solve that issue. If you followed all the advice about installing UT on the JingPad then just try the installer again. there maybe help in the JingPad section of the Forum if not try here https://t.me/WelcomePlus I have not got a JingPad so cannot really help with that.
-
@miy Make sure you are not using a USB3 port on your PC.
-
@ian
I use a USB 3 on my computer to connect with the JingPad. I did find that the cable supplied with the JingPad did not work. I used a cable that I knew worked with my Pixel 4a. -
@el_pinguino There is a known problem using USB3 wirh the installer. Either use a USB2 port if you have one or connect to your device via a USB2 hub.
-
@ian
Thanks for the info. I did not know this.
