Meizu MX4 arale ubuntu edition problems switching to UBports
-
Hi,
I used the ubports-installer tool to flash my MX4 from Ubuntu to UBports. I followed the onscreen instructions, enabled developer mode on the mx4, and initiated the process.
Right now, the ubports-installer tool shows a rotating circle around the mascot and on the MX4 there is a black screen with => FASTBOOT mode... written in the lower left corner.
However, the ubports-installer tool also has a gray bar below the mascot showing:
Meizu MX4 Please connect your device with an usb cable.
But wasn't that written there all the time? I did not pay attention on this.
Should I unplug the USB cable from my Mac or do I brick my phone by doing this?
How long will flashing approximately take?
Currently, I have waited about half an hour.Thanks for your feedback.
-
@absurd Hi, Welcome to UBports. Please also try asking your question in the welcome and install group on telegram,
They will know the answer and you may get a quicker answer there. Also when your sorted why not have a look at
https://ubports.com/page/telegram-welcome
for more info you may find helpful.
-
@lakota Thank you for the advice. I crossposted this to the Telegram channel now.
-
@absurd great hope you get sorted quickly
