@moem No I don't want to sell it. I am going to keep it because I think UT will be very functional soon enough.

What worked for me installing Waydroid on OP5t OTA24 Stable was installing from the Terminal using the following commands: sudo -s sudo mount -o remount,rw / apt update apt install waydroid -y waydroid init sudo waydroid session stop sudo sed '/aidl/s/2/3/' -i /etc/gbinder.d/anbox.conf sudo reboot Best regards, Steve Berson

Last update: Scenerio 1: When charging the JingPad during use (i.e. OS is running) and I disconnect the charging cable before shutdown there will be no problem. If I then reconnect the charging cable to the JingPad it will show the green charging animation. If I then disconnect the charging cable something will keep running and discharge the battery. If I reconnect the charger ( after disconnecting it once) nothing will happen visably. No charging animation. Scenario 2: If I connect the charging cable to the JingPad when not in use the JingPad will show the green charging animation. If I then disconnect the charging cable something will keep running and discharge the battery. If I reconnect the charger ( after disconnecting it once) nothing will happen visably. No charging animation. Generally, the time from pressing the power on button to the buzz signaling the bootup, is 3 seconds. If The JingPad is in this unknown discharging state the time to the buzz is 9 seconds. So, charging my JingPad when the OS is not running leads to problems. I guess I'll just have to charge the JingPad during use and remember to disconnect the charger before shutting down. Thanks for all of the suggestions.

I cannot get into recovery mode Boot loops until the battery dies. Any ideas? Right, got into recovery mode, think the problem was I left it connected to computer as battery had died.....

@marioqqq Thanks. I am gearing up to make the switch.