time in screen

wally

Even just enabling the System Settings icon in the top tray via Lomiri Plus Essentials from Ambot Installer fixes the issue of not seeing the full time on my Oneplus N10.

To me, this seems like the simplest system-wide fix. Wouldn't fix rounded edges across the board. But at least the time is visible for those of us with rounded screens and 24hr clocks.

Thanks a million, @kugiigi, for all your work!

bdomecq

Ah, OK, I got it now and the issue is fixed.

Thank you @kugiigi and @Vlad-Nirky

Taking the opportunity, I noticed that OTA updates were blocked by the ambot installer. Does this mean that this adjustment I have done to fix the time that was clipped out in the top right corner will affect OTA updates?

kugiigi

@bdomecq You should have read the dialog in Ambot Installer
Basically, it's advisable to reset all components in Ambot Installer before installing an OTA update. If you do this, OTA updates won't be blocked anymore.

bdomecq

@kugiigi My phone just ran into a problem. I think my phone was hacked. There was a blue screen that appeared quickly and saying something that my personal information would be sold.

arubislander

@bdomecq Your phone was not hacked. It is a prank that gets installed along with the ~~havks~~ customizations in Ambot Installer.

kugiigi

@bdomecq That's part of Lomiri Plus If you just need the notch fix, you can just install Lomiri Plus Essentials for a minimal changes to the system and has no surprises like that

bdomecq

@kugiigi and @arubislander I already knew it. I was just pranking back ! That was very nice and funny though!

Thank you!

@kugiigi, regarding the dialog, yes, I had read it attentively before noticing the messages about the updates. I asked a bad question. I would like to ask in fact is just to confirm I understood well, i.e. that once resetting the components to make room for the updates, the time clipping issue would take place again, but after the update is run, I could run this again and fix it. Is that correct?

kugiigi

@bdomecq Yes, you can reset all components then install the OTA then install them again. Depending on the changes in the OTA, packages may become incompatible and I would need to update them.

bdomecq

@kugiigi it worked with the latest OTA update. Thank you.

Is there a way to adjust the display so it fully fills the screen? It has a space of almost a cm at the bottom...

kugiigi

@bdomecq I actually can't figure out what's causing that I was able to eliminate that on my FP5. I played around with the notch configuration but I can't for sure identify which fixes it and why or how.

bdomecq

@kugiigi OK. Anyway, thank you.