The OTA-22 Roll Out Has Started

magnargj

When I woke up there was a notification about OTA-22 on my phone. How nice! a feature arrived with ota-21?

Keneda

@magnargj said in The OTA-22 Roll Out Has Started:

a feature arrived with ota-21?

A comeback, if you read blog post :

Note also that starting with OTA-22 we try to bring back the broadcast facility, which will send each device a trigger message.

We can say it's a success ^^

glocester

"Support for camera in Morph browser. Now video calls finally work! This is probably the most important feature of this OTA"

Can't use your camera for an unknown reason :confused_face:

Keneda

@glocester
What is your device ?
Some, like MX4, are blacklisted from this new feature, so it won't work on those.

Edit : bl device are
BQ E4.5 and E5
Meizu MX4
Nexus 4
Nexus 7 2013

nifgraup

@ubportsnews I ran the commands from the release post to get the OTA-22 update already

sudo system-image-cli -v -p 0 --progress dots

and now the phone doesn't boot. OnePlus 6.

Lakotaubp

@nifgraup jfi what update channel was your OP6 on before? If nothing else you might need to rerun it through the installer.
Edit: What I mean is does the OP6 have a stable channel. I don't have this device.

cliffcoggin

OTA-22 downloaded and installed successfully today, however the notification for it was labelled as OTA-20.

domubpkm

On Volla, RC v 50 is OTA-22, so no need to switch.

Keneda

@cliffcoggin
Are you sure ?
Update was labeled as "update 20" or something like that for me in system update, but not "OTA" .

glocester

@keneda
¿struggle with WebRTC and/or WebGL quite a bit. WebGL?
OK.
Thank you.

cliffcoggin

@keneda Then I must have misread it. Old eyes and mucky specs are my excuses.

nifgraup

@lakotaubp It was stable channel. Thanks for the tip about rerunning through the installer. I dodn't know how easy that was and all my data was untouched. I'm now on OTA-22.

joolz

I have OTA-22 running for a few days now (on OPO Bacon) and so far battery life appears to be much better than it used to be. Thanks!

Billboy5690

Trying to force the rollout to my device.( having poor performance with new battery)
Can some one help me with these steps.

"If however you would like to receive the update immediately, turn on ADB access and issue the following command over adb shell:

sudo system-image-cli -v -p 0 --progress dots "

Is this done on pc ( maybe platform tools).how do you turn on adb access?

flohack

@magnargj the notification was always a feature we could use, however at some point it was dropped or idk. I brought it back since I find it annoying myself that we never know when the update is ready

magnargj

@flohack it was such a satisfaction, thanks!

Keneda

@billboy5690
If you don't know, so are not familiar with ssh and adb remote shells, you should wait for update too reach your device "naturally".

Billboy5690

@keneda I have used the platform tools with ADB just not sure of the proceedure,is it done in terminal on phone or is the phone connected to pc and done that way.

Keneda

@billboy5690
Phone connected to PC with adb link, ADB shell on PC.

bre34

I have read that UT is moving more towards the main Ubuntu distribution. How would this affect the way we run and design apps for UT? Would Libertine still be required?