Thanks @lk108 !
Indeed, it's the same issue as for DeltaTouch : when I reboot with Wifi enabled and connected, notifications appear. Don't know for how long though...
Hope it will be fixed soon!

Hello!
Exactly the same problem here, using Ubuntu Touch 24.04-1.1 on Fairphone 4.
The notifications used to work fine until around two months ago (even after upgrading to 24.04), then works sporadically and now not working any longer.
Notifications are working properly for Dekko et SMS.
I've tried clearing cache and configuration of the app or desabling/allowing the notifications for the app but nothing really helps...
Any ideas?

Thanks !

Yes, had the same problem this morning after the update on my VollaPhone. I reflashed it from the UT installer (not ticking the wipe option) choosing the RC channel and it rebooted fine!

@ezze I've just cheked TELEports on my Nexus 5 and it works fine... I had some connection issues when signing on a few months ago, but it worked after a few tries.

Hi, just to say that I eventually managed to install Ubuntu touch using the BQ's flash tool and firmware!
I haven't work on upgrading to UBports yet, but I'll try soon...
Thanks all for your help!

@freebobjohn I have exactly the same issue with my BQ M10 FHD!
Did you find a way to install UBports till december? Thanks, Emmelyne

I think I get rid of one of the problem: my OEM wasn't properly unlock and after having doing it well I was able to run the magic-device-tool!
But I'm now stuck with the recovery mode of frieza and when I choose the reboot the device, I getting the powered by android image with the Orange state alert and nothing happens...
So I try to follow the post of 29 may 2017 07:28 of this topic :Can't get the M10 FHD to take the flash, but when I run the "df -h" I can see (image) that my system partition is only 1.5G and the userdata one is only 774.9M!
How could that be?
Thanks again

0_1512592466373_M10DevicePartitions.png

Hi @fulvio
I've tried the UBPorts installer, which seems really simple indeed!
But when I connect my BQ M10 FHD, I've got the message that "Device Aquaris_M10_FHD" is not supported (see image ).
Any idea why?
Thank you!!
0_1512585110338_DeviceNotSupported.png

Ok, thank you both!
I'll try some of the mention solutions and let you know.

@Lakota, thanks
Yes, I've seen this post before !
But when I connect my m10 in recovery mode and try to run the commands on terminal, I get a "could detect device" (or something close).
Whereas when I run the MDT, it says "device detected"...