Support

Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

子版面

New Contributors

This section is specifically useful for new contributors on the project

5 主題

15 貼文

F

@idonthatevests Would it be useful for hosting the images that the ubports mirrors pull, or is it sort of the same situation there?
Libertine

Discuss and solve problems with other users

94 主題

674 貼文

P

https://forums.ubports.com/topic/11532/signal-ut-signal-desktop-for-ubuntu-touch
Waydroid

157 主題

1k 貼文

E

@Sentinel said in No GPS access from inside Waydroid: maybe the MIUI version I flashed might have impacted Waydroid's reliability or other things? Yes — this can significantly affect UT. The MIUI image version to use is specified in the installation guide under "2. Check the correct version of MIUI", and it looks like you used the correct one. I can't explain the unusual bugs you've reported. Did you remount the system as read-write and make any changes? Did you use apt (update/upgrade/install)? I'm fine with starting a new discussion thread.

D

HiSense Sero 7 E270BSA Tablet

關注中忽略中已排程已置頂已鎖定已移動
10

0 評價

10 貼文

2k 瀏覽

A

@danix803 I've found these instructions, I don't have a Sero 7, so read them before try it (to see if those steps make sense to you). Hold power and volume down while its powered off for 10 seconds ...if the hisense sign comes up keep holding it down until you see the screen flash and its off again and release and press it again and repeat it until you see the green android guy and then power + vol up...for 3-5 seconds until menu comes up Good luck!
D

opo camera

關注中忽略中已排程已置頂已鎖定已移動
2

0 評價

2 貼文

505 瀏覽

A

@dr1445 16.04 is not out yet, and developers are working on those issues as you can see here https://github.com/ubports/ubuntu-touch/issues
J

Fastboot: booting...FAILED (remote: bootimage: incomplete or not signed)finished.

關注中忽略中已排程已置頂已鎖定已移動
39

0 評價

39 貼文

15k 瀏覽

5

@james YMMD, finally a working solution.Using the old installer (0.1.9) did the trick.
N

Looking to Install to an old NextBook Premium Tablet

關注中忽略中已排程已置頂已鎖定已移動
3

0 評價

3 貼文

468 瀏覽

N

OK, rip. Sucker's only got a kernel version of 3.0.8. Thanks for the assist.
M

16.04 update ,dev,ver 108

關注中忽略中已排程已置頂已鎖定已移動
13

0 評價

13 貼文

2k 瀏覽

L

@locamama Hi this may well get lost here. If I were you I would start a fresh post in the support section and call it something like 16.04 Browser issue. That way those who know these things will be able to find it quicker. One thing to try before that would be to change your update settings to dev channel if you are still on rc. That will get you the latest upto date system and see if that fixes it. sorry I can't move it for you or would have done.
D

TERMINAL FILE OF COMMAND LINES

關注中忽略中已排程已置頂已鎖定已移動
4

0 評價

4 貼文

504 瀏覽

A

@domubpkm of course. Thank you for your how-to.
M

Ubuntu/Components package for Ubuntu 18.04 X86_64 (qt5)

關注中忽略中已排程已置頂已鎖定已移動
1

0 評價

1 貼文

425 瀏覽

尚無回覆
T

Xenial rc fails to boot on Meizu MX4

關注中忽略中已排程已置頂已鎖定已移動
55

0 評價

55 貼文

17k 瀏覽

L

@thepossessor Thanks for letting me know, and a big welcome back to the Luxembourg timezone
D

FILE MANAGER Ubports 0.6.0

關注中忽略中已排程已置頂已鎖定已移動
1

1 評價

1 貼文

435 瀏覽

尚無回覆
H

Unable to access “MX4 Ubuntu Edition” Unable to open MTP device '[usb:001,012]

關注中忽略中已排程已置頂已鎖定已移動
2

0 評價

2 貼文

812 瀏覽

L

@happyzenith It might not be the cables etc. How well does the cable fit into the phone itself? When I used mine daily it was always fun using Ubuntu to see if the phone connected : ) Once had ten different windows open telling me it couldn't open mx4. It would only work on one USB port and at the right angle. Try wiggling the cable at the phone end the connection is tricky, that or use Linux mint ; ) that always seemed better. Try it on dev if your still on RC just in-case that helps Edit Trying to remember now but sure I had best results with a short phone charging cable rather than the longer ones. Edit two. Last one honest. If you have UT Tweak Tool on your mx 4 you can check adb settings and that MTP is ok by choosing system from the menu and usb settings
D

HOTSPOT ONE PLUS ONE BACON

關注中忽略中已排程已置頂已鎖定已移動
1

2 評價

1 貼文

445 瀏覽

尚無回覆
S

Playing Music from smb share

關注中忽略中已排程已置頂已鎖定已移動 smb music
1

0 評價

1 貼文

631 瀏覽

尚無回覆
M

Bug report from Nexus 5

關注中忽略中已排程已置頂已鎖定已移動
3

0 評價

3 貼文

667 瀏覽

J

messages bug is already reported: https://github.com/ubports/messaging-app/issues/28 however, you can add more comments, etc...
A

Install Ubuntu Touch in Blu Dash Jr Android v 2.3.5

關注中忽略中已排程已置頂已鎖定已移動
9

0 評價

9 貼文

1k 瀏覽

A

@anonymouswh there isn't an alternative solution other than trying to port UT to that device. No existe ninguna solución alternativa que no pase por portar UT a ese teléfono.
S

In Libertine, dosbox window very small,Is there a way to amend it?

關注中忽略中已排程已置頂已鎖定已移動
3

1 評價

3 貼文

932 瀏覽

S

@killerbee Okay, thanks. I'll try.
K

BQ E4.5 Clock / Time reset & Alarm clock doesn`t work

關注中忽略中已排程已置頂已鎖定已移動
6

0 評價

6 貼文

950 瀏覽

L

@kkovacs Good, any further problems just pop back
K

BQ E4.5 Cellular data cannot be switched on or off

關注中忽略中已排程已置頂已鎖定已移動
6

0 評價

6 貼文

1k 瀏覽

K

thank you!
?

此主題已被刪除！

關注中忽略中已排程已置頂已鎖定已移動
1

1

0 評價

1 貼文

1 瀏覽

尚無回覆
D

where is phone #

關注中忽略中已排程已置頂已鎖定已移動
3

0 評價

3 貼文

726 瀏覽

D

thanks, i got it by putting the sim in my android phone.
K

Easiest way to activate phone on a carrier

關注中忽略中已排程已置頂已鎖定已移動
12

0 評價

12 貼文

2k 瀏覽

K

So I got the phone to work on Metro PCS - Lte, however Only works so far for calling and texting. Was not able to successfully get Data in and out but will keep trying.

158 / 180