@cannonfodder Try sudo reboot -f recovery
Best posts made by DenMoore
-
RE: WARNING: LOCK FLAG IS : UNLOCK, SKIP VERIFY!!!
-
RE: The state of Volla x23, for all users out there.
@Rinkeby Volla have a FAQ section on their web site with information about setting up/running dual boot. You cannot update via OTA or change channels. You update within dual boot when an updated image is released. Cheers
-
RE: Ubuntu Touch on JingPad
@writersglen Instructions here https://forums.ubports.com/topic/7567/how-to-install-ubuntu-touch-on-the-jingpad-a1-c1/31 You need windows to unlock bootloader, installer on linux is fine. Cheers
Latest posts made by DenMoore
-
RE: Wifi, battery and pinetab 2
@FP2andFP3-User Approx half as fast as using a dongle connected to the same source. I believe the driver for wifi is still in its early stages. Cheers
-
RE: Wifi, battery and pinetab 2
@FP2andFP3-User Wifi works, a little slow. You just need to enable it once UT is installed. Battery life very good, charges in a couple of hours.
-
RE: The state of Volla x23, for all users out there.
@Rinkeby Volla have a FAQ section on their web site with information about setting up/running dual boot. You cannot update via OTA or change channels. You update within dual boot when an updated image is released. Cheers
-
RE: Jingpad isn't detected in USB for installing Ubuntu-Touch
@Suleiman Same for me. I just select the Jingpad manually and all works fine. Cheers
-
RE: Ubuntu Touch Q&A 123 call for questions
@Lakotaubp Thank you for the link, Cheers
-
RE: Ubuntu Touch Q&A 123 call for questions
@Keneda I see, that makes sense. Thank you for the answer.
-
RE: Ubuntu Touch Q&A 123 call for questions
@UBportsNews I was wondering what the path/procedure is for ports to end up on the UBports installer ie the PinePhone/PineTab2 focal port? Cheers
-
RE: Screen replacement on volla phone 22
@myrtaki I think I read somewhere on telegram that an update for the new screens would be released at end of this month or early August. I would check with customer service again, or ask here https://t.me/hello_volla before buying another screen.
-
RE: WARNING: LOCK FLAG IS : UNLOCK, SKIP VERIFY!!!
@cannonfodder Try the following. Turn off the pad completely. Once you are sure it has shut down, Hold the power button down, wait one second then hold the 'volume down button' as well until the Logo appears then release both buttons. It is all about timing. If you are too early/late with the volume button, then you have to power down again and try again.
It took me a few attempts at first. Also note the pad cannot be completely shut down if plugged into any power ie charger or computer.
What worked for me, was too boot into recovery (via buttons or command), then start the installer, select Pad manually, follow installer instructions and when the instruction is to boot into recovery, then plug the pad into the computer.
Hope this helps
Cheers -
RE: WARNING: LOCK FLAG IS : UNLOCK, SKIP VERIFY!!!
@cannonfodder Ok, so what OS is installed? Cheers