@MrRoughwood Yeah, keep on checking different settings. I've done the same when I was trying to figure out my battery drain issue. It needs an overnight test so it takes a long time

@ferrieux 24.04 is currently not the stable version of Ubuntu Touch. Maybe installing the stable version (currently 20.04 (OTA-9) focal) could solve your problems. I think the ubports installer should also show you what version is stable.

@Rebecca58 I need: full, rock-solid Nextcloud client support. Nextcloud file sharing through the File Manager YubiKey two-factor identification support a good password manager compatible with KeePassXC

@RJDan Could you try explicitly referencing the key file with the clone? git clone -c core.sshCommand="ssh -i ~/.ssh/my_gitlab_ssh_key" \ git@gitlab.com:MyUserName/docs.ubports.com.git

Had there been an update with volte support being added to UB touch now ? I have a oneplus 6t running 20.4 I think it is. I have us cellular and can't get any mobile calls or data or Anything to work. Since us cellular is t mobile I was hoping there was a way to make it work.

Hi MrRoughwood, Congratulations! And it's a very good decision to start with “stable.” Greetings Mario

And it was suggested that I move this conversation to the open-store group. Sorry for posting it in the wrong place. So no worries if you don't address this during the stream.

@Technotramp If by using the Ubports installer does not continue to change it to fastboot, you must do it manually, without disconnecting the cable being careful is to press power and volume down until the ubports installer continues its installation, this is a common problem in the Ubports installer Regards...

@Opolork thank you

A puzzling issue is that when I see the prompt 'waydroid is stopped' in the UT command line, Waydroid is actually running, and operations within its system GUI appear to be functioning normally.

its working since todays update to version 3.1.3

@dosolly Hello, Sorry for only responding to your help now. I searched my provider's website, but there was no information other than to change my mobile phone. Therefore, I will visit one of this provider's shops as soon as I have time. Thank you again.

@arubislander said in unknown filesystem type 'overlay'.: @dafeihong you probably want to run those tools in a LXD container. Try searching for LXD on Ubuntu Touch in the forum. Thank you very much. It sounds like the container solution I need. I'll go check its support for these tools.

@MrT10001 I did not use trwp just local update. But I did get it to go. I reset the phone, used the zip from the XDA link you put, then used a different computer with a fresh ubuntu install, flash UB24 from there it booted into recovery, I then flashed UB20 from the installer and was able to update to 24. Not sure why that worked but it did. Thank you for helping. EDIT so I posted that while it was updating to 24.0 and it rebooted right back to recovery and that was it, I was able to re flash 20.0. So I assume 24.0 just does not work on the 6t as of yet, which is cool since it is still new.

@wgarcia Very good idea, will try this!